Home Tournaments Calendar Weather Merchandise Sponsors

Go Back   Spearboard.com - The World's Largest Spearfishing Diving Boating Social Media Forum > phil herranen

Conversation Between phil herranen and freediver4life
Showing Visitor Messages 1 to 1 of 1
  1. freediver4life
    01-17-2017 04:25 PM
    freediver4life
    Hey Phil! I recently got done applying teak oil to a solid teak stock. But after taking out on a test dive, I noticed a hairline crack coming through where I screwed in the front loop guide. The crack is about 3 - 1/2 inches long running through the screw holes of the front loop guide. I initially applied your 2 part epoxy to try and get much of it back into the screw holes and over the crack. At this point I'm a little hesitant of leaving the gun with an oil finish and am leaning towards doing it with your 2 part epoxy with a matte finish. My question is...Do I sand off most of the oil finish..Or can I still apply the epoxy over the stock with it oiled up? I appreciate any help. Thank you for your time.

    Jake

All times are GMT -5. The time now is 12:40 PM.


The World's Largest Spearfishing Diving Social Media Forum Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2002 - 2014 Spearboard.com