View Single Post
Old 04-18-2016, 02:25 PM   #1
Gator97dwb
Registered User
 
Gator97dwb's Avatar
 
Join Date: Mar 2003
Location: Longwood, FL
Age: 49
Posts: 97
Question Roll control mounting on curve ideas

I want to mount a 24" section of the aluminum rail on each side of my SeaCat just forward of the console. There is slight curve and the rail gets about 1/4" seperation from the fiberglass in the middle. I bought the mounting kit but by the time you stack those pieces it sets the rail to far out (more than necessary) and gives my kids another thing to hurt themselves on. Also allows for little fingers to slip behind and get caught. However, without it the rail ends are all that contacts the wall and that can't be good over time.

I am looking for ideas on how others solved this problem. I thought about sanding down one side of mounting block to make it thinner and match the curve but that will be a big effort to get right. Any other ideas?

Thanks.
Gator97dwb is offline   Reply With Quote