Going water jet service rates - Spearboard.com - The World's Largest Spearfishing Diving Boating Social Media Forum

waveman1981 · 06-10-2012, 07:27 AM

Creating some dxf. files on CAD for some custom hardware I am designing for my guns. Most of the hardware will be cut on a waterjet with my files and supplied stainless steel. The majority will be cut on 3/16'' steel. From my research i am assuming the rates will be either per inch or per min/hr. of run time roughly. Does any one know what a fair going rate should be for this service. Also I may send out my files to a few services for quotes . Also now that i am gathering some knowledge in this area it seems like making the basic hardware for a trigger mech would be fairly simple given the correct proportions cut/ braking/ and tig welding. Who out there is making there own trigger mechs?


Home	Tournaments	Calendar	Weather	Merchandise	Sponsors

06-10-2012, 07:27 AM	#1
waveman1981 Registered User Join Date: Nov 2009 Location: Point Pleasant NJ Posts: 280	Going water jet service rates Creating some dxf. files on CAD for some custom hardware I am designing for my guns. Most of the hardware will be cut on a waterjet with my files and supplied stainless steel. The majority will be cut on 3/16'' steel. From my research i am assuming the rates will be either per inch or per min/hr. of run time roughly. Does any one know what a fair going rate should be for this service. Also I may send out my files to a few services for quotes . Also now that i am gathering some knowledge in this area it seems like making the basic hardware for a trigger mech would be fairly simple given the correct proportions cut/ braking/ and tig welding. Who out there is making there own trigger mechs? Last edited by waveman1981; 06-10-2012 at 07:45 AM.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread: