Wong Question?

[jamesa184]

I have not been spearfishing in a few years because of work but I am leaving last minute on a spearfishing trip and need to replace the bands on my 55in Magnum. I can not remember the lengths for each of the 3 bands needed. I believe they are 26in 27in and 28in but I am not sure. Would anybody be able to clarify the correct length to cut the bands? I apologize I know I could of did a search for this but I do not have much time as we are leaving soon and I still need to pack. Thanks, -James.

[Bill McIntyre]

I think those lengths are correct. If you wish, you could check with this formula.

1. Measure the distance from the middle of the
band slot to the center cocking tab.

2. Double the distance ( for both sides of the gun )

3. Subtract the length of the wish bone. (Alexander and Riffe's are
approx 6", Daryl Wong uses about 3".)

4. Divide the number by 3 1/2.

5. This is the length of your powerband if you are using a standard 3 1/2
: 1 stretch ratio. This is a measurement of the powerband from knot to
knot. For actual rubber length, add 1" to this length or 1 1/2" in you
are tapering the ends of the powerbands.

If you have separate holes for each band as with the newer Aimrite/Wong muzzles, then rather than measuring from the center of the band slot (you don't have a slot) to the middle tab, measure from each hole to the appropriate tab, and you will have a different band length for each hole.

[jamesa184]

Thanks! just made the bands after i got done packing and it worked out great the formula was pretty close to the original bands.

[Blue Man]

Does anyone know if these are the correct lengths for the Wong 55 GR as well?

Also, what diameter bands does Daryl use? I seem to remember they might be non standard diameter bands, but I can't be sure.

[Bill McIntyre]

Originally Posted by Blue Man

Does anyone know if these are the correct lengths for the Wong 55 GR as well?

Also, what diameter bands does Daryl use? I seem to remember they might be non standard diameter bands, but I can't be sure.

I think the lengths should be the same for the GR and the Magnum.

I wouldn't swear to it, but I think Daryl ships 5/8" bands with the Magnums and 9/16" with the GR. In any event, that's what I use on my guns.

[Blue Man]

Thanks Bill.

[Rocky Mountain Spearo]

Originally Posted by Blue Man

Does anyone know if these are the correct lengths for the Wong 55 GR as well?

Also, what diameter bands does Daryl use? I seem to remember they might be non standard diameter bands, but I can't be sure.

From the man himself to me a few days ago regarding the same question.

"Aloha Chad,

Bands I have on my gun and that I send out are 5/8 x 26,27 in wishbones are 3.5 in between knots.

Aloha,Daryl"

Aloha,
Chad

[Blue Man]

Thanks Chad. Same gun? (55 GR)

[Rocky Mountain Spearo]

Yes sir. 55GR

[Blue Man]

Thank you!