Home Tournaments Calendar Weather Merchandise Sponsors

Go Back   Spearboard.com - The World's Largest Spearfishing Diving Boating Social Media Forum > Dr.P

Conversation Between Dr.P and Straits
Showing Visitor Messages 1 to 1 of 1
  1. Straits
    08-18-2018 08:19 PM
    Hi Dr P. I’m building a few short crayfish guns and am following your momobloc tung oil process. Sounds like you did the pockets and holes first, then fitted components before doing the exterior/exposed surface. Did you find the mech didn’t fit and needed the slot sanded back after that many coats? Same question for the pin holes? Thanks in advance.

All times are GMT -5. The time now is 03:07 PM.

The World's Largest Spearfishing Diving Social Media Forum Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2002 - 2014 Spearboard.com